26AWG 100MM XH2.5 Pitch 5pin GH 1.25mm 14p cable with JST connector VW-1 AWM 1007
application for JST connectors are automotive and communication
PCB JST Distribution Control Cable
Cable with JST and molex connector
The JST-XH standard has a 2.5mm pin spacing. On the one end is a 4-pin JST-XH male connector and on the opposite end bare cables. It also comes with the mating female connector. This product comes bundled with 4 connector pairs. Although the JST-XH use 2.5mm pitch it works very good in most 2.54mm pirch applications like vero or proto board.
servo extension cable with JST connector and Molex connector.
Compatible with Microaces servos and receivers.
Other cable below:
10cm 2.54mm Male Female Cable Connector 2PIN JST Plug Connector Wire Cable RC Lipo Battery
JST connectors are used in many types ofproducts, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers, battery eliminator circuits, and radio controlled servos.
Pitch:2.5mm
Connector:JST XH 2.5mm 2Pin
Wire length: Customized
Other cable below:
Product Name:DC 5521 5525 opening cable
Product Length:As your require
Wire type: 18AWG or 20awg (inside black and red wire)
Contactor: According to your requirements, can connect with RJ45, JST, Molex and other connectors
Conductor Material:Tin-plated copper
Insulation material:PVC insulation
Conductor Material:Tin-plated copper Wire
5.5mm x 2.1 mm DC power supply male repair cable is widely used for worn or damaged power cords, such as 12V 24V DC power supply equipment,LED light strips, CCTV security surveillance camera systems or low voltage application systems,etc.
The end of the cable is black and red to indicate the polarity. Pure copper wire can provide faster and more stable conductivity, which can be better connected to other equipment. (DC 5521 male plug corresponding cable:red to inside, black to external)
Double 1.5mm² copper wire, thicker wire diameter than 18AWG, allowing higher current equipment to pass (Does not support data transfer)
The DC power cord is 1m long (about 3FT), which is enough to complete most of the projects. It can also be cut as required. The double-layer PVC insulation layer is safer and corrosion-resistant. It can also be bent as needed and is very flexible.
The end of the DC5521 power cord has been pre-stripped and tin-plated, which is easy to solder and install,connect.
Audited Supplier 
){kind=link}